Connectivity is a key step in WiZ Pro Setup.

You can decide to select Bluetooth.

In this case, the devices will stay in the local network they have defined among themselves.

However, the products will not appear as connected when looked at via the WiZ app or WiZ Pro Dashboard, this is because those interfaces rely on cloud connectivity to monitor and control the devices and on local Wi-Fi.

Having bluetooth only for now allows you to come back to the Site and add Wi-Fi credentials later on.

You can decide to select Wi-Fi.

In this case, you will be prompted to enter a Wi-Fi network SSID and Password to give to the lamps. When this network is deployed, the lamps will automatically try to connect to it (either every 1 hour or after reboot).

After network credentials are entered and if your phone is also connected to this network, you can run a check test to see if all the necessary ports are open and the network is ready for devices to connect on.

Note that a key advantage of WiZ Pro Setup is that you can give network credentials to the devices even before any network is deployed.

Also note that if you joined a Site using a commissioning code for which the network credentials were provided, the Wi-Fi network information will be pre-filled and ready to pass on to the devices.

If you wish to give different network credentials to different devices in a single Site, you can do so sequentially, entering credentials and only syncing those to certain devices in the Sync Products step. Then go back, change credentials and sync to other devices.